Search Results

An all-ceramic swirl chamber has been developed and analyses and evaluations concerning the strength of silicon nitride ceramic (Si3N4) have been performed with a view to using it for the entire internal wall surface of the swirl chamber. The strength characteristics of Si3N4 and their effect and variation have been determined. On the basis of measurements and analyses of thermal stresses, assembling stresses, etc., investigation of the most suitable construction and assembling methods to reduce load stresses on ceramic, and various kinds of duration tests, the swirl chamber has been confirmed to have the required durability. This engine was found to comply with the 1987 U.S. diesel particulate regulation.

The sequential fuel injection, in which fuel is injected into swirl being generated for mixture stratification, was used to pursue the potential of a lean burn engine for its performance improvement. As a result, it has been found that the most effective method to increase thermal efficiency while reducing NOx emission level is to combine a high-compression compact combustion chamber located on exhaust valve side in cylinder head with DICS (Dual induction Control System). This method was used to build a high-compression lean burn concept vehicle, which was evaluated for compliance to various emission standards. Testing showed that the concept vehicle can improve fuel economy by 10.5% on the Japanese 10-mode cycle, by 8.3% on the ECE mode cycle, and by 6.3% on the U.S. EPA test mode cycle while meeting respective emission standards.

For the purpose of satisfying today's market demands, new 8 and 11 liter diesel engines, named "STORM" series, have been developed and moved into production in 1986. Based on the predecessors which have been produced since 1975, the development of the STORM series aimed high performance, low emission, long life-time and low operating costs. In order to consult customers' convenience, exchangeability of engine parts and commonality of vehicle installations with the former engines had to be maintained. This paper describes the development work of STORM engines, and the design aspects and performance characteristics of these engines.

CORRELATION OF BENDING STRENGTH AND ERRORS OF HELICAL GEAR has not been clarified sufficiently even now. As the investigation by using only experimental method is not sufficient and so the analytical method of obtaining gear bending strength has been developed by one of the authors. Hence, the correlation of bending strength and errors, especially in the aspect of the direction of pressure angle error and tooth trace error, is clarified by this analytical method which was verified by some experiments. And by further investigations, it is confirmed that the helical gear is tougher against the negative pressure angle error, and the fine module gear is sensitive against the errors.

In this paper a computer simulation study on the effects of steering parameters on lateral dynamics of the guideway bus to contribute to a development practice of designing optimum steering control system are dealt with. A stability limit of vehicle lateral motion is analyzed and an emphasis is laid on the effects of moment of inertia of a conventional steering wheel and lateral elasticity of the guide rail which have proven to reduce the critical vehicle speed. It is pointed out conclusively that a normal bus equipped with additional simple guidance equipments can be guided smoothly on a simple guideway at adequately high vehicle speed.

The influence of the tyre properties on the driving behaviour of single-track vehicles has been measured by performing running tests with full-scale vehicles. The indoor dynamic tyre measurements using the sideslip angle as the input signal reveale that the sideforce and self-aligning moment characteristics are helpful explaining the measured driving behaviour. The obtained tyre parameters values and second order equations have been implemented in the simulation program ADINA-MOBSIP. This program is specially conceived for the simulation of the driving behaviour of single-track vehicles and is based on the finite element method.